Supported Systems

Supported Systems

macOS

  1. Plugin formats: VST3, AU, AAX.
  2. Mojave 10.14 to Ventura 13 on 64bit Apple OS and 64bit Hardware.
  3. CPU Apple Silicon or Intel.
  4. Core Audio based audio interface (Internal or External) for Digital Audio Workstation (DAW) main audio output^
  5. 2GB RAM available on top of DAW requirements*.
  6. 100MB disk space for the software installation.
  7. USB port on the computer for direct connection.
  8. 1280x800 (or higher) display resolution.

Windows 

  1. Plugin formats: VST3
  2. Windows 10 (Build 1909 and later) and Windows 11. 64Bit OS. 
  3. CPU Intel® Core™ i5 (or higher) processor or an AMD Ryzen 5 (or higher) multi-core processor with minimum 4-cores and minimum 2Ghz processor speed.
  4. ASIO based audio interface for DAW main audio output^.
  5. 2GB RAM available on top of DAW requirements*.
  6. 100MB disk space for the software installation.
  7. USB port on the computer for direct connection.
  8. 1366x768 (or higher) display resolution.

Digital Audio Workstations

  1. Ableton Live 10 (or higher) 64bit.
  2. Bitwig Studio 4 (or higher)  64bit.  (plugin hosting mode set to: Within Bitwig)
  3. Cubase 11 and Nuendo 11 (or higher) 64bit.
  4. Studio One 6 (or higher See Notes ) 64bit.
  5. Logic Pro X (or higher)  64bit.
  6. Protools on OSX (Apple Silicon and Rosetta).
  7. Reaper 6.8 (or higher)
  8. Reason 12.6 (or higher)
  9. FL Studio 21.1 (or higher)
  10. Other DAWs may work but have not been officially tested and therefore not officially supported (yet) - please contact support if you intend to purchase freqport product to run on a different DAW than listed above.
  11. Optimal main audio interface buffer-size setting should be 512 samples (or lower).

^ Freqtube is a real-time hardware based plugin and as such off-line rendering cannot be used in your DAW project. This may be different from your usual workflow.
Before using any real-time plugin, and before using freqtube , its important that your system can playback your DAW projects in real-time without any dropouts.
Freqport system runs separately to the main audio I/O used in the DAW. Use a Core Audio or ASIO audio interface as you DAW main interface and run your DAW project at low latency (preferably 512 samples or lower) without audio dropouts before using freqtube. 

* Freqport system uses under 100MB RAM however it is highly recommended to have memory overhead for any real-time audio project. 

    • Related Articles

    • PC Downloads

      Latest Installer: Please click the link below to download and install freqport software for PC:. DOWNLOAD FREQTUBE v1.5.7 VST3 WIN CHANGE LOG Important notes: Please refer to Supported Systems and read Optimizing DAW articles on this site before ...
    • MAC Setup

      Please follow these setup notes for MacOS computers. Privacy & Security: Please set to Allow accessories to Connect to Always (Earlier MacOS versions only): When running first time CLICK OK to allow permissions (pic below). If you don't click OK then ...
    • Optimizing your DAW

      General information Freqtube is a real-time hardware based plugin and real-time rendering needs to be used in your DAW project when bouncing or recording (not off-line bounce). The freqport system runs separately to the main audio I/O used in your ...